Ncr S16 Bedienungsanleitung PDF herunterladen (Seite 23)

Configuring the SCSI Adapters

NCR S16 Minitower Server Installing Network Operating System 3-3

Configuring the SCSI Adapters

To configure the SCSI adapters, if connected to an Adaptec SCSI adapter,

follow these steps:

1. Press Ctrl + A when the following displays:

Adaptec AIC-7880 Ultra/Ultra W BIOS

Press <Ctrl><A> for SCSISelect (TM) Utility

Refer to Chapter 5 of the NCR S16 Minitower Server User Guide

(BST0-2142-00) for additional information about these settings.

2. Select SCSI Disk Utilities. Verify that all the SCSI devices are displayed

with correct information. If a low-level format on the hard disk drive is

needed, perform it now. Usually it is not needed.

3. Select Configure/View Host Adapter Settings and set the parameters as

follows:

SCSI Bus Interface Definitions

Host Adapter SCSI ID 7

SCSI Parity Checking Enabled

Host Adapter SCSI Term Low OFF/High ON

Boot Device Options:

Boot Target ID 0

Boot LUN Number 0

4. Select SCSI Device Configuration and set the parameters as follows:

SCSI Device ID (tab to desired device)

Initiate Sync Negotiation Yes

Maximum Sync Transfer Rate 20

Enable Disconnection Yes

* Initiate Wide Negotiation Yes

*For Wide devices only.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 107 108

Keine Kommentare

Ncr S16 Bedienungsanleitung Seite 23